HY-TC601: Thermostat (normally closed NC) is used to regulate the heater or heating device, avoiding continuous operation, saving electricity, and extending the lifespan of the heater (automatically turning off the heater or heating device when the temperature is above the set value)

KTO 011. The rmostat/normally closed)，contact breaker for regulating heaters.
KTS 011: Thermostat(normally open)， contact maker for regulating of filter fansand heat exchangers or for switching sianal devised when temperature limit hasbeen exceeded.

FKO 011 ：The rmostat(normally closed), contact breaker for regulating heaters.
FKS 011 ： Thermostat(normally open), contact maker for regulating of filter fans and heat exchangers or for switching signal devised when temperature limit has been exceeded.

The 7T.81 industrial temperature controller is mainly designed to regulate the internal temperature of the cabinet, allowing the environment inside the cabinet to fluctuate within a comfortable range, ensuring the normal operation of equipment components, and avoiding damage caused by equipment overheating. Effectively save energy and extend equipment life. The flat design effectively saves space, and the wide temperature design can meet the needs of various industrial equipment cabinets.

HY-TC603: Normally open, normally closed integrated constant temperature (two circulating temperature control switch units integrated into a single shell)

Two thermostats in one casing ：
Thermostat(contact breaker, normally closed)for regulating heaters.
Thermostat(contact maker,normally open)for regulating filter fans and heat exchangers or switching signal devices when temperature limit has been exceeded. Heaters and cooling equipment can be switched independently from each orther with atemperature offset as opposed to the usual change-over contacts.

The electromechanical hygrostat MRF 012 is designed to control enclosure heaters sothat the dew point is raised when a critical relative humidity of 65%is exceeded. In thisway condensation and corrosion is effectively prevented.

Tamperproof(Pre-set)Thermostat FTO 01 1
Contact breaker/NC(red casing)for regulating heaters or for switching signal devices when temperature has fallen below the minimum value. The contact opens Wnen temperatu re is rlslna.

Electronic thermostats are used to control heaters, air coolers, or signaling devices.

The electronic hygrotherm senses the ambient temperature and relative humidity in anenclosure with electric/electronic component, and turns on a heater(or alternatively, a fan)ateither set point, helping prevent the formation of condensation in the enclosure. The LEDintegrated in the adjustment knob on the active controller is lit when the connected devicelS in operation.

Especially used for controlling fan filter, heater and exchanger, also could be monitoring the electric cabinetinner temperature when working as signal arcuser.

When the preset relative humidity in the control cabinet is exceeded, turn on the heating device or fan.
Therefore, the relative humidity can be increased above the dew point to avoid the formation of condensation on components or electronic components.